RE: FW: iSCSI: "conservative reuse" requirement

["John Hufferd" <hufferd@us.ibm.com>]

Eddy,
There can be parallel Sessions from the same Initiator NODE but not from
the same Initiator SCSI Port (which I call the Initiator iSCSI/SCSI Port).
It is invalid to have more then one Session between an Initiator SCSI Port
and a specific Target SCSI Port (which I call the Target iSCSI/SCSI Port).

The Identifier of the Initiator iSCSI/SCSI Port is the Concatenation of
Initiator Node Name and the ISID.  The Identifier of the Target iSCSI/SCSI
Port is the Concatenation of the Target Node Name and a Target Portal Group
Tag.

SAM-2 Initiator Port Identifier, in the context of iSCSI, is the Identifier
of what I called the Initiator iSCSI/SCSI Port.

.
.
.
John L. Hufferd
Senior Technical Staff Member (STSM)
IBM/SSG San Jose Ca
Main Office (408) 256-0403, Tie: 276-0403,  eFax: (408) 904-4688
Home Office (408) 997-6136, Cell: (408) 499-9702
Internet address: hufferd@us.ibm.com


"Eddy Quicksall" <Eddy_Quicksall@ivivity.com>@ece.cmu.edu on 12/28/2001
11:19:33 AM

Sent by:    owner-ips@ece.cmu.edu


To:    Jim Hafner/Almaden/IBM@IBMUS
cc:    "ips@ece. cmu. edu \(E-mail\)" <ips@ece.cmu.edu>
Subject:    RE: FW: iSCSI: "conservative reuse" requirement



Due to 2.5.3 (b) "Between a given SCSI initiator port and SCSI target
port, there can be only one I_T nexus (session)", aren't we always
"assuming no more than one session"?

Or are you talking about more than one session between different SCSI
initiator ports and a single SCSI target port?

Is the ISID equivalent to SAM-2's Initiator Port Identifier?


Eddy

-----Original Message-----
From: Jim Hafner [mailto:hafner@almaden.ibm.com]
Sent: Friday, December 28, 2001 12:15 PM
To: John Hufferd; Eddy Quicksall; Mallikarjun C.; Black_David@emc.com
Cc: ips@ece.cmu.edu
Subject: Re: FW: iSCSI: "conservative reuse" requirement


Folks,

Sorry for taking so long to jump into this discussion.

There are a number of issues raised in this thread:
1) should "conservative reuse" of ISIDs be made a MUST
2) does "conservative reuse" imply that all hosts look "single SCSI
ported"

Here's my two cents (using "CR" as a shorthand for "conservative
reuse")

I don't believe that CR needs to be a MUST.  The only time this has
any
real value is in configurations that use SCSI persistent reservations
(and
where new SCSI target reservation features are enabled -- NB.  these
features are yet to be approved but are working their way through the
process). I don't think these are going to be (even in the future) the
majority of installations.  There are many ways then that CR could be
something that is not generally available in most drivers but is added
by
configuration and perhaps even "value add" (:-{)).

In short, I don't see a strong case for this to be a MUST.  So, to
David
Black, my answer is that having a mechanism to enable this feature or
have
it as a "purchase requirement" is an acceptable mechanism to make sure
the
feature is there when needed, but it is need not be a requirement of
the
protocol.  To Mallikarjun, I think I'm agreeing with you that so long
as
there is a mechanism defined, iSCSI has done it's job.

As for the second issue (raised by Mallikarjun), let's look at the
definition of CR.  What is means is that when an iSCSI initiator
(node)
creates ISIDs for use in session identifiers, it attempts to reuse
them
as
much as possible with different SCSI target ports (iSCSI target portal
groups).  This is the only way that a SCSI target or LU can see the
same
SCSI initiator port through two or more of its SCSI target ports --
that
is, that the target can determine multiple paths *from* the same SCSI
initiator port.   But, the model for generating ISIDs is not really at
the
node level but at the initiator portal group level.
So, IMO, the conclusion that all hosts must then look "single SCSI
ported"
is too dramatic.  As I mentioned,  ISIDs are conceptually generated
within
initiator portal groups (that's why we defined the mechanism for
generating
ISIDs).  The conclusion I draw is that (assuming no more than one
session
to any given target portal group), an iSCSI initiator implementing CR
will
have as many SCSI initiator ports as iSCSI initiator portal groups
(independent HBAs?).  Each initiator portal group would generate one
ISID
(that is different from that generated by/for the other initiator
portal
groups) and use CR for repeatability.  [This is consistent with a
model
that mapped SCSI initiator ports to initiator portal groups, which we
had
to abandon because the "assuming no more than one session..." was no
acceptable as a requirement!!!]  This independence of ISIDs for each
initiator portal group allows each initiator portal group to open
sessions
with *every* target portal group it knows about without having to
worry
about interfering with other sessions. [This has shades of the
"partitioning" rule for ISIDs that has been discussed ad nauseum!!!]

(I have a feeling that this note is not well composed -- it is the
holidays, you know).  I hope I've addressed everyone's concerns and we
can
lay this one to rest.

Jim Hafner


John Hufferd
12/25/2001 08:49 AM

To:   "Eddy Quicksall" <Eddy_Quicksall@iVivity.com>
cc:   Jim Hafner/Almaden/IBM@IBMUS
From: John Hufferd/San Jose/IBM@IBMUS
Subject:  Re: FW: iSCSI: "conservative reuse" requirement  (Document
link:
      Jim Hafner)

You are correct.  The section was created by Jim Hafner, and via this
note
I will ask him if he could answer Mallikarjun Directly since I did not
understand his issue.

.
.
.
John L. Hufferd
Senior Technical Staff Member (STSM)
IBM/SSG San Jose Ca
Main Office (408) 256-0403, Tie: 276-0403,  eFax: (408) 904-4688
Home Office (408) 997-6136, Cell: (408) 499-9702
Internet address: hufferd@us.ibm.com


"Eddy Quicksall" <Eddy_Quicksall@iVivity.com> on 12/24/2001 06:06:44
PM

To:   John Hufferd/San Jose/IBM@IBMUS
cc:
Subject:  FW: iSCSI: "conservative reuse" requirement



John,

Were you the author of "conservative reuse"? I am wondering about some
issues. Maybe you could educate me somewhat ...

I started this subject in a different thread by saying that it may be
good to make "conservative reuse" a MUST.

I got one objection from Santosh below. Then David Black picked it up
by basically agreeing with me. Then Mallikarjun objected to that.

It seems like the objective would be to give targets a way to figure
out that two or more sessions are coming from the same Initiator Port.
That is needed support persistent reservations.

If an initiator does not use "conservative reuse", I don't think
targets will be able to make that determination.

Comments?

Eddy

-----Original Message-----
From: Mallikarjun C. [mailto:cbm@rose.hp.com]
Sent: Monday, December 24, 2001 12:47 AM
To: Black_David@emc.com
Cc: ips@ece.cmu.edu
Subject: Re: iSCSI: "conservative reuse" requirement

> I think this is headed towards "conservative reuse" being a MUST if
> we're serious about support for shared persistent reservations.

Mandating "conservative reuse" appears to force initiators to always
act
as a single initiator port (wrt one target; assuming only one session
as
an
example) per initiator device - which rules out the case of an
initiator

intentionally wanting to present a different port to each target
portal
group.

IMHO, if iSCSI provides an architected mechanism to support shared
persistent reservations ("conservative reuse"),  that should be
completely
adequate to meet the expectations to be a legal SCSI protocol.
--
Mallikarjun

Mallikarjun Chadalapaka
Networked Storage Architecture
Network Storage Solutions Organization
Hewlett-Packard MS 5668
Roseville CA 95747

----- Original Message -----
From: <Black_David@emc.com>
To: <santoshr@cup.hp.com>
Cc: <ips@ece.cmu.edu>
Sent: Friday, December 21, 2001 4:50 PM
Subject: iSCSI: "conservative reuse" requirement


> Santosh Rao writes:
>
> > I am opposed to the suggestion that "conservative re-use" of ISIDs
be
> > made a MUST. This is really only required when initiators need to
be
> > using the new T10 Reservation scheme that can be shared
> > across initiator ports.
>
> Those reservations are a Target feature.  With this approach, the
ability
> to use the target feature depends on details of the initiator
> implementation.
> More below ...
>
> > For those initiators that don't care about this type of
reservation,
> > conservative re-use is of no use and initiators may like to assign
> > ISID's in a per-initiator node fashion, thereby, being able to use
these
> > ISIDs as a lookup index for the sessions on that initiator node.
> >
> > Hence, I suggest that "conservative re-use" be worded as
> > "encouraged to use" or something to that effect, but not MUST USE.
> >
> > Comments ?
>
> The "initiator" is more than one entity.  The iSCSI HBA/NIC and
driver
> doesn't know whether shared persistent reservations are being used
and
> shouldn't have to care - they're just more SCSI commands to
transport.
> Some other entity (e.g., clustering software) will be generating the
> shared persistent reservations.  This raise the possible scenario
> involving a target that supports the new shared persistent
reservations
> and an entity that wants to use them.  The entity detects (via SCSI
means,
> e.g., something in a mode page) that the Target supports shared
persistent
> reservations, tries to use them, only to discover that they don't
work
> because the iSCSI HBA/NIC doesn't implement "conservative reuse".
>
> I'm worried about this causing both interoperability issues and
possible
> T10 issues -- from a T10 viewpoint, if shared persistent
reservations
> don't work, the initiating entity should have some SCSI-level means
> of determining this ... if that means exists only on the Target, the
> above scenario is iSCSI's problem (Target can't query Initiator to
> determine whether it does "conservative reuse"), and having a
separate
> initiator side means that the entity has to check only for iSCSI
(and
> not for any other SCSI transport) does not seem like the right
> approach.
>
> I think this is headed towards "conservative reuse" being a MUST if
> we're serious about support for shared persistent reservations.
>
> Comments?
> --David
> ---------------------------------------------------
> David L. Black, Senior Technologist
> EMC Corporation, 42 South St., Hopkinton, MA  01748
> +1 (508) 249-6449 *NEW*      FAX: +1 (508) 497-8500
> black_david@emc.com         Cell: +1 (978) 394-7754
> ---------------------------------------------------
>
>