|
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] Re: iSCSI: One Node or Two?David. It is possible that this 2 way target has two different Names. However, since the SCSI Initiator Port is a dynamically created entity, and the only unique part of its ID (within the Initiator Node) is its ISID, there is no reason there has to be a different iSCSI Node Name. An implementation, however, could create a node that is uses for all iSCSI Initiator functions, however, there is no hard reason for that, and depending on how it is named it may either be more or less confusing to the Administrator. . . . John L. Hufferd Senior Technical Staff Member (STSM) IBM/SSG San Jose Ca Main Office (408) 256-0403, Tie: 276-0403, eFax: (408) 904-4688 Home Office (408) 997-6136, Cell: (408) 499-9702 Internet address: hufferd@us.ibm.com David Dillard <david.dillard@veritas.com>@ece.cmu.edu on 01/28/2002 08:03:24 AM Sent by: owner-ips@ece.cmu.edu To: "IETF IPS Workgroup Reflector (E-mail)" <ips@ece.cmu.edu> cc: Subject: iSCSI: One Node or Two? As defined in the latest draft an iSCSI Node "... represents a single iSCSI initiator or iSCSI target." By this definition an LU that acts as both an initiator and a target, such as a data mover for extended copy, is two iSCSI nodes. This LU will have two iSCSI names, one for the initiator side of the LU and one for the target. Therefore, there will be two iSNS "entries" for this LU. My question is: Is this intended? Regards, David
Home Last updated: Mon Jan 28 15:18:04 2002 8521 messages in chronological order |