SORT BY:

LIST ORDER
THREAD
AUTHOR
SUBJECT


SEARCH

IPS HOME


    [Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

    iSCSI: Response codes in SCSI Response Command



    Current definition states
     

    2.4.2 Status/Response

    The Status field is used to report the SCSI status of the command (as specified in [SAM2]). The Response is used to report a Service Response. The exact mapping of the iSCSI response codes to SAM service response symbols is outside the scope of this document. If a SCSI device error is detected while data from the initiator is still expected (the command PDU did not contain all the data and the target has not received a Data PDU with the final bit Set) the target MUST wait until it receives the a data PDU with the F bit set before sending the Response PDU.

    Valid iSCSI Response codes are:

    0x01 - Target Failure

    0x02 - Delivery Subsystem Failure

    0x03 - Unsolicited data rejected

    0x04 - SNACK rejected

    0x80-0xff - Reserved for Vendor-Unique Responses

     

    DONT YOU THINK that these response codes be actually mapped in SAM document and be made as standard to be followed by any protocol. So iSCSI should also report the same responses as defined in SAM document.

    Regards,

    Sanjeev

     



Home

Last updated: Tue Sep 04 01:04:31 2001
6315 messages in chronological order